Cisco WAP351 - Viewing Details for a Single Point Setup Member

Single Point Setup
Wireless Neighborhood
Cisco WAP131 and WAP351 Administration Guide 185
11
• White Bar—A white bar and the number 0 indicates that a neighboring
device that was detected by one of the cluster members cannot be
detected by the device whose IP address is listed above that column.
• Light Gray Bar—A light gray bar and no signal strength number indicates
that no signal has been detected from the neighbor, but the neighbor may
have been detected by other members of the cluster.
• Dark Gray Bar—A dark gray bar and no signal strength number indicates
the WAP device itself that corresponds to the IP address listed above it. A
signal strength of zero is displayed because the device’s own signal
strength is not measured.
Viewing Details for a Single Point Setup Member
To view details on a cluster member, click the IP address of a member at the top of
the page.
The following details for the device appear below the Neighbors list:
• SSID—The Service Set Identifier for the neighboring access point.
• MAC Address—The MAC address of the neighboring access point.
• Channel—The channel on which the access point is currently broadcasting.
• Rate—The rate in megabits per second at which the access point is
currently transmitting. The current rate is always one of the rates shown in
Supported Rates.
• Signal—The strength of the radio signal detected from the access point,
measured in decibels (dB).
• Beacon Interval—The beacon interval used by the access point.
• Beacon Age—The date and time of the last beacon received from the
access point.