Cisco WAP351 - Configure Ipv6 Acls

ACL
ACL Rule
Cisco WAP131 and WAP351 Administration Guide 140
8
check for an IP ToS value having bits 7 and 5 set and bit 1 clear, where bit
7 is most significant, use an IP ToS Bits value of 0 and an IP ToS Mask of
00.
STEP 6 Click Save. The changes are saved to the Startup Configuration.
NOTE To delete an ACL, ensure that it is selected in the ACL Name-ACL Type list, select
Delete ACL, and click Save.
Configure IPv6 ACLs
To configure an IPv6 ACL:
STEP 1 Select ACL > ACL Rule.
STEP 2 In the ACL Name field, enter the name to identify the ACL.
STEP 3 Choose IPv6 as the type of ACL from the ACL Type list. IPv6 ACLs control access
to network resources based on Layer 3 and Layer 4 criteria.
STEP 4 Click Add ACL.
STEP 5 In the ACL Rule Configuration area, configure these ACL rule parameters:
• ACL Name - ACL Type—Choose the ACL to configure with the new rule.
• Rule—Choose New Rule to configure a new rule for the selected ACL. When
an ACL has multiple rules, the rules are applied to the packet or frame in the
order in which you add them to the ACL. There is an implicit deny all rule as
the final rule.
• Action—Choose whether the ACL rule permits or denies an action.
When you choose Permit, the rule allows all traffic that meets the rule
criteria to enter the WAP device. Traffic that does not meet the criteria is
dropped.
When you choose Deny, the rule blocks all traffic that meets the rule criteria
from entering the WAP device. Traffic that does not meet the criteria is
forwarded unless this rule is the final rule. Because there is an implicit deny
all rule at the end of every ACL, traffic that is not explicitly permitted is
dropped.