Cisco WAP351 - Page 64

Administration
Spanning Tree Settings
Cisco WAP131 and WAP351 Administration Guide 64
3
To configure the STP settings on the Cisco WAP351:
STEP 1 Select Administration > Spanning Tree Settings.
STEP 2 Configure these parameters:
• STP Status—Enables or disables STP globally on the Cisco WAP351. By
default, STP is enabled.
• Flood BPDU if STP is disabled on port(s)—Check to flood the BPDU
packets received from the port(s) whose STP status is disabled, or uncheck
to drop the BPDU packets received from the port(s) whose STP status is
disabled.
• Per Port STP Status Setting—Check to enable STP on a port, or uncheck
to disable STP on a port.
STEP 3 Click Save. The changes are saved to the Startup Configuration.