Cisco WAP351 - Page 15

Getting Started
Using the Access Point Setup Wizard
Cisco WAP131 and WAP351 Administration Guide 15
1
STEP 17 Select whether or not to set up an authentication method for guests on your
network, and click Next.
If you click No, skip to Step 25.
If you click Yes , the Enable Captive Portal - Name Your Guest Network window
appears.
STEP 18 Specify a Guest Network Name.
STEP 19 Click Next. The Enable Captive Portal - Secure Your Guest Network window
appears.
STEP 20 Choose a security encryption type for the guest network and enter a security key.
For a description of these options, see Configuring Security Settings.
STEP 21 Click Next. The Enable Captive Portal - Assign the VLAN ID window appears.
STEP 22 Specify a VLAN ID for the guest network. The guest network VLAN ID should be
different from the management VLAN ID.
STEP 23 Click Next. The Enable Captive Portal - Enable Redirect URL window appears.
STEP 24 Check Enable Redirect URL and enter a fully qualified domain name (FQDN) or IP
address in the Redirect URL field (including http://). If specified, the guest
network users are redirected to the specified URL after authenticating.
STEP 25 Click Next. The Summary - Confirm Your Settings window appears.
STEP 26 Review the settings that you configured. Click Back to reconfigure one or more
settings. If you click Cancel, all settings are returned to the previous or default
values.
STEP 27 If they are correct, click Submit. Your setup settings are saved and a confirmation
window appears.
STEP 28 Click Finish.
The WAP device was configured successfully. You are required to log in again with
the new password.