7-2
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 7 Configuring SDM Templates
Configuring the Switch SDM Template
The rows in the tables represent approximate hardware boundaries set when a template is selected. If a
section of a hardware resource is full, all processing overflow is sent to the CPU, seriously impacting
switch performance.
Configuring the Switch SDM Template
These sections contain this configuration information:
• Default SDM Template, page 7-2
• SDM Template Configuration Guidelines, page 7-2
• Setting the SDM Template, page 7-2
Default SDM Template
The default template is the default.
SDM Template Configuration Guidelines
When you select and configure SDM templates, you must reload the switch for the configuration to take
effect.
Setting the SDM Template
Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
IPv6 multicast groups 0 0 0
Directly connected IPv6 addresses 0 0 0
Indirect IPv6 unicast routes 0 0 0
IPv4 policy-based routing aces 0 0 0
IPv4 MAC QoS ACEs 128 384 0
IPv4 MAC security ACEs 384 128 256
IPv6 policy-based routing aces 0 0 0
IPv4 MAC QoS ACEs 0 0 0
IPv4 MAC security ACEs 0 0 0
Table 7-1 Approximate Number of Feature Resources Allowed by Each Template (continued)
Resource Default QoS Dual
Command Purpose
Step 1
configure terminal Enter global configuration mode.
To Next Page
Loading...
Need help?
General
