31-8
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 31 Configuring EtherChannels and Link-State Tracking
Configuring EtherChannels
Figure 31-3 Load Distribution and Forwarding Methods
Configuring EtherChannels
These sections contain this configuration information:
• Default EtherChannel Configuration, page 31-9
• EtherChannel Configuration Guidelines, page 31-9
• Configuring Layer 2 EtherChannels, page 31-10 (required)
• Configuring EtherChannel Load Balancing, page 31-12 (optional)
• Configuring the PAgP Learn Method and Priority, page 31-13 (optional)
• Configuring LACP Hot-Standby Ports, page 31-14 (optional)
Note Make sure that the ports are correctly configured. For more information, see the “EtherChannel
Configuration Guidelines” section on page 31-9.
Note After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
101239
Cisco router
with destination-based
forwarding enabled
EtherChannel
Switch with
source-based
forwarding enabled
To Next Page
Loading...
