EasyManuals Logo

Cisco WS-C2960-24LC-S User Manual

Cisco WS-C2960-24LC-S
730 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #231 background imageLoading...
Page #231 background image
10-9
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 10 Configuring Interface Characteristics
Configuring Ethernet Interfaces
This example shows how to define an interface-range named enet_list to include ports 1 and 2 and to
verify the macro configuration:
Switch# configure terminal
Switch(config)# define interface-range enet_list gigabitethernet0/1 - 2
Switch(config)# end
Switch# show running-config | include define
define interface-range enet_list GigabitEthernet0/1 - 2
This example shows how to create a multiple-interface macro named macro1:
Switch# configure terminal
Switch(config)# define interface-range macro1 fastethernet0/1 - 2, gigabitethernet0/1 - 2
Switch(config)# end
This example shows how to enter interface-range configuration mode for the interface-range
macro enet_list:
Switch# configure terminal
Switch(config)# interface range macro enet_list
Switch(config-if-range)#
This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.
Switch# configure terminal
Switch(config)# no define interface-range enet_list
Switch(config)# end
Switch# show run | include define
Switch#
Configuring Ethernet Interfaces
These sections contain this configuration information:
Default Ethernet Interface Configuration, page 10-9
Setting the Type of a Dual-Purpose Uplink Port, page 10-10
Configuring Interface Speed and Duplex Mode, page 10-12
Configuring IEEE 802.3x Flow Control, page 10-14
Configuring Auto-MDIX on an Interface, page 10-15
Adding a Description for an Interface, page 10-16
Default Ethernet Interface Configuration
Table 10-1 shows the Ethernet interface default configuration. For more details on the VLAN
parameters listed in the table, see Chapter 12, “Configuring VLANs.” For details on controlling traffic
to the port, see Chapter 19, “Configuring Port-Based Traffic Control.”
Table 10-1 Default Layer 2 Ethernet Interface Configuration
Feature Default Setting
Allowed VLAN range VLANs 1 to 4094.
Default VLAN (for access ports) VLAN 1.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C2960-24LC-S and is the answer not in the manual?

Cisco WS-C2960-24LC-S Specifications

General IconGeneral
BrandCisco
ModelWS-C2960-24LC-S
CategoryNetwork Router
LanguageEnglish

Related product manuals