D-1
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
APPENDIX
D
Unsupported Commands in
Cisco IOS Release 12.2(40)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2960 switch prompt but are not supported in this release, either because
they are not tested or because of Catalyst 2960 switch hardware limitations. This is not a complete list.
The unsupported commands are listed by software feature and command mode.
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
show accounting
show ip accounting [checkpoint] [output-packets | access violations]
show ip cache [prefix-mask] [type number]
Unsupported Global Configuration Commands
access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended
Unsupported Route-Map Configuration Commands
match ip address prefix-list prefix-list-name [prefix-list-name...]
To Next Page
Loading...
Need help?
General
