1-11
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• No passwords are defined. For more information, see Chapter 6, “Administering the Switch.”
• System name and prompt is Switch. For more information, see Chapter 6, “Administering the
Switch.”
• NTP is enabled. For more information, see Chapter 6, “Administering the Switch.”
• DNS is enabled. For more information, see Chapter 6, “Administering the Switch.”
• TACACS+ is disabled. For more information, see Chapter 8, “Configuring Switch-Based
Authentication.”
• RADIUS is disabled. For more information, see Chapter 8, “Configuring Switch-Based
Authentication.”
• The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
information, see Chapter 8, “Configuring Switch-Based Authentication.”
• IEEE 802.1x is disabled. For more information, see Chapter 9, “Configuring IEEE 802.1x
Port-Based Authentication.”
• Port parameters
–
Interface speed and duplex mode is autonegotiate. For more information, see Chapter 10,
“Configuring Interface Characteristics.”
–
Auto-MDIX is enabled. For more information, see Chapter 10, “Configuring Interface
Characteristics.”
–
Flow control is off. For more information, see Chapter 10, “Configuring Interface
Characteristics.”
• No Smartports macros are defined. For more information, see Chapter 11, “Configuring Smartports
Macros.”
• VLANs
–
Default VLAN is VLAN 1. For more information, see Chapter 12, “Configuring VLANs.”
–
VLAN trunking setting is dynamic auto (DTP). For more information, see Chapter 12,
“Configuring VLANs.”
–
Trunk encapsulation is negotiate. For more information, see Chapter 12, “Configuring
VLANs.”
–
VTP mode is server. For more information, see Chapter 13, “Configuring VTP.”
–
VTP version is Version 1. For more information, see Chapter 13, “Configuring VTP.”
–
Voice VLAN is disabled. For more information, see Chapter 14, “Configuring Voice VLAN.”
• STP, PVST+ is enabled on VLAN 1. For more information, see Chapter 15, “Configuring STP.”
• MSTP is disabled. For more information, see Chapter 16, “Configuring MSTP.”
• Optional spanning-tree features are disabled. For more information, see Chapter 17, “Configuring
Optional Spanning-Tree Features.”
• Flex Links are not configured. For more information, see Chapter 21, “Configuring Flex Links and
the MAC Address-Table Move Update Feature.”
• DHCP snooping is disabled. The DHCP snooping information option is enabled. For more
information, see Chapter 22, “Configuring DHCP Features and IP Source Guard.”
• IGMP snooping is enabled. No IGMP filters are applied. For more information, see Chapter 18,
“Configuring IGMP Snooping and MVR.”
To Next Page
Loading...
Need help?
General
