30-7
Catalyst 2960 Switch Software Configuration Guide
OL-8603-04
Chapter 30 Configuring IPv6 MLD Snooping
Configuring IPv6 MLD Snooping
To globally disable MLD snooping on the switch, use the no ipv6 mld snooping global configuration
command.
Beginning in privileged EXEC mode, follow these steps to enable MLD snooping on a VLAN.
Note When the IPv6 multicast router is a Catalyst 6500 switch and you are using extended VLANs (in the
range 1006 to 4094), IPv6 MLD snooping must be enabled on the extended VLAN on the Catalyst 6500
switch in order for the Catalyst 2960 switch to receive queries on the VLAN. For normal-range VLANs
(1 to 1005), it is not necessary to enable IPv6 MLD snooping on the VLAN on the Catalyst 6500 switch.
To disable MLD snooping on a VLAN interface, use the no ipv6 mld snooping vlan vlan-id global
configuration command for the specified VLAN number.
Step 4
copy running-config startup-config (Optional) Save your entries in the configuration file.
Step 5
reload Reload the operating system.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ipv6 mld snooping Globally enable MLD snooping on the switch.
Step 3
ipv6 mld snooping vlan vlan-id Enable MLD snooping on the VLAN.The VLAN ID range is 1 to
1001 and 1006 to 4094.
Note MLD snooping must be globally enabled for VLAN snooping
to be enabled.
Step 4
end Return to privileged EXEC mode.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
