Cisco XR 12000 Command Reference

(Optional) Node ID. The node-id argument is entered in the rack/slot/module
notation.
node-id
(Optional) Specifies all locations.all
(Optional) Displays the list of racks.rack
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
This command can generate a very large amount of output. You may want to redirect the output to a file
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Tip
Use the show tech-support lrd command for the LRD debugging, which controls the Secure Domain Router
(SDR) architecture. The system always has at least one SDR at any time. It collects relevant information when
issues arise with the SDR management within the system. This command can be useful for Cisco Technical
Support representatives when troubleshooting a router. See 'Obtaining Documentation and Submitting a
Service Request' section on page iii in the Preface for Cisco Technical Support contact information.
This command is not required during normal use of the router.Note
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Task ID
OperationsTask ID
readcisco-support
Examples
The following example shows some of the show tech-support lrd command output that is displayed on the
terminal:
RP/0/0/CPU0:router# show tech-support lrd terminal page
-------------------------------------------------------------------------------
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
OL-28456-02 203
Tech-Support Commands
show tech-support lrd

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English