Cisco XR 12000 Command Reference

(Optional) Specifies that the command output is displayed one page at a time.
Use the return key to display the next line of output or use the space bar to
display the next page of information. If not used, the output scrolls (that is, it
does not stop for page breaks).
Press the Ctrl+C keys to stop the command output.
page
(Optional) Specifies the tunnel number that is used by the RSVP process.tunnel-number
(Optional) Number for the tunnel. The range is from 0 to 65535.
number
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
This command can generate a very large amount of output. You may want to redirect the output to a file
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Tip
This command generates MPLS-TE information that can be useful for Cisco Technical Support representatives
when troubleshooting a router. See 'Obtaining Documentation and Submitting a Service Request' section on
page iii in the Preface for Cisco Technical Support contact information.
This command is not required during normal use of the router.Note
See the Cisco IOS XR Software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR Software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Task ID
OperationsTask ID
readcisco-support
readmpls-te
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
OL-28456-02 225
Tech-Support Commands
show tech-support mpls traffic-eng

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English