Cisco XR 12000 - Show Tech-Support Ethernet

show tech-support ethernet
To automatically run show commands that display information specific to ethernet debugging, use the show
tech-support ethernet command in EXEC mode.
show tech-support ethernet [file send-to [background] [compressed| uncompressed]] [interface| location
node-id| rack]
Syntax Description
(Optional) Specifies that the command output is saved to a specified file.file
(Optional) Name of the file. The following valid options are listed:
•
filename
•
bootflash: filename
•
compactflash: filename
•
disk0: filename
•
disk1: filename
•
flash: filename
•
ftp: filename
•
harddisk: filename
•
harddiska: filename
•
nvram: filename
•
rcp: filename
•
slot0: filename
•
slot1: filename
•
tftp: filename
sent-to
(Optional) Collects the status and configuration information about a specific
interface.
interface
(Optional) Specifies a node.location
(Optional) Node ID. The node-id argument is entered in the rack/slot/module
notation.
node-id
(Optional) Specifies a list of racks.rack
Command Default
IPv4 is the default.
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
OL-30353-01 197
Tech-Support Commands
show tech-support ethernet