Cisco XR 12000

show tech-support pos
To automatically run show commands that display information specific to Packet over SONET /SDH (POS)
debugging, use the show tech-support pos command in EXEC mode.
show tech-support pos {terminal [page]| file send-to [background] [compressed| uncompressed]} interface
type instance [show-only] [trace-only] [location node-id| all] [rack]
Syntax Description
Specifies that the command output is saved to a specified file.file
Name of the file. The following valid options are listed:
•
filename
•
bootflash: filename
•
disk0: filename
•
disk0a: filename
•
disk1: filename
•
disk1a: filename
•
ftp: filename
•
harddisk: filename
•
harddiska: filename
•
harddiskb: filename
•
nvram: filename
•
rcp: filename
•
tftp: filename
sent-to
(Optional) Specifies that the command runs in the background.background
(Optional) Displays compressed command output.compressed
(Optional) Displays the command output with no compression.uncompressed
Collects information about a specific interface.interface
Interface type. For more information, use the question mark (?) online help function.
type
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
OL-30353-01 295
Tech-Support Commands
show tech-support pos