Cisco XR 12000

Examples
The following example shows some of the show tech-support routing rpl command output:
RP/0/0/CPU0:router# show tech-support routing rpl terminal page
Mon Nov 10 18:53:02.220 PST DST
-------------------------------------------------------------------------------
start of show tech-support routing rpl
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
RPL CLients Configuration
-------------------------------------------------------------------------------
router ospf 100
router-id 10.2.2.2
nsf cisco
area 0
mpls traffic-eng
interface Bundle-POS24
!
interface Loopback0
passive enable
!
interface GigabitEthernet0/1/5/1
!
interface GigabitEthernet0/1/5/2
bfd fast-detect
!
interface GigabitEthernet0/6/5/1
!
interface POS0/1/0/1
!
interface POS0/1/0/2
!
interface POS0/1/0/3
!
interface POS0/6/0/1
!
interface POS0/6/4/4
!
interface POS0/6/4/6
!
interface POS0/6/4/7
!
!
mpls traffic-eng router-id Loopback0
!
Mon Nov 10 18:53:03.313 PST DST
% No such configuration item(s)
Mon Nov 10 18:53:03.975 PST DST
router isis lab
is-type level-2-only
net 49.1122.0000.0000.0002.00
interface Loopback0
passive
address-family ipv4 unicast
!
!
interface POS0/1/0/2
address-family ipv4 unicast
!
!
interface POS0/1/0/3
address-family ipv4 unicast
!
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
338 OL-30353-01
Tech-Support Commands
show tech-support routing rpl