35
Chapter 2 Printer Operation
Mode Settings
Turning the power o while the printer is performing the “Save
Settings” function could cause a mis-save. Do not do this! If the power
is accidentally turned o, rst reset the printer to factory defaults.
Menu Setup Mode
If the MENU key is pressed while the printer is in the Ready state, the
printer enters menu setup mode. In this mode, the printer’s conguration
can be changed using the operation panel. During menu setting mode,
the LCD indicates the current menu settings and the key function.
4 3
2
1
Functions of the keys
When you enter Menu Setup Mode, the LCD displays “Main Menu” on the
top line and Page Setup below.
In the menu setup mode, the four keys become “cursor keys” to navigate
the menu.
1
MENU key (Shift/Change):
The MENU key goes up the menu system or selects a higher value
2
Feed key (Shift/Change):
The Feed key (
n
) goes down the menu system or selects a lower
value
3
Stop key (Enter/Save):
The Stop key (
g
) selects or saves the item or enters a menu
4
Pause key (Exit):
The Pause key (
e
) exits the current item (goes back) and eventually
exits the menu system
The menu settings are stored temporarily in the printer’s memory. They
are only permanently stored in the printer setup when you exit the menu
system and say “Yes” to the “Save Settings” question.
Caution
To Next Page
Loading...
Need help?
General
