CT-S310II Series Service Manual
- 8 -
4. Disassembling “CASE-03”
Pull the right and left panels of “CASE-03” at the bottom center outwardly.
(Be sure to disengage the lugs at the front and rear from “FRAME, BOTTOM-03”.)
When raising “CASE-03”, pull the left panel of “CASE-03” outwardly to avoid contacting “LEVER L,
CUTTER RELEASE” on the left side, and pull the right panel outwardly to avoid contacting “LEVER,
COVER OPEN-03” on the right side.
Remove “SCREW, BHT (BT) M3.0 8” that fastens “LEVER, FEED SW-03”.
<Precaution at reassembly>
Align holes on “LEVER, FEED
SW-03” with bosses on
“CASE-03”.
Remove “CASE-03” while
keeping the lugs clear of
“FRAME, BOTTOM-03”.
Fastening lugs
CASE-03
SCREW, BHT (BT), M3.0 8
LEVER, FEED SW-03
To Next Page
Loading...
