CT-S310II Series Service Manual
- 9 -
5. Disassembling “FRAME, BOTTOM-03”
Remove two “SCREW, BHT (ST), M3.0 6” that fasten “FRAME, BOTTOM-03” and “FRAME, MAIN-03”.
Disconnect connectors from “SA, MAIN PCB”.
J2: HEAD
J3: MOTOR
J7: AUTO CUTTER
J8: COVER OPEN SENSOR (TOP COVER)
J9: COVER OPEN SENSOR (FRONT)
J10: PAPER SENSOR
<Precaution at disassembly / reassembly>
Do not pull the cable by force.
When reassembling, be careful not to catch the
cable.
“FRAME, BOTTOM-03” and “FRAME, MAIN-03” are secured with hooks at the bottom. Slide “FRAME,
BOTTOM-03” to disengage it from “FRAME, MAIN-03”.
<Precaution at reassembly>
Check that hooks on the right and left are securely inserted.
When securing “FRAME, BOTTOM-03” with screws, align the boss at “FRAME, BOTTOM-03” with the hole at
“FRAME, MAIN-03”.
SCREW, BHT (ST), M3.0 6
J3 J9 J8 J10 J7
J2
“FRAME, BOTTOM-03” side “FRAME, MAIN-03” side
Hooks
Boss
To Next Page
Loading...
