CT-S310II Series Service Manual
- 13 -
7. Disassembling “SA, THERMAL HEAD-03”
Hold the right and left side of “HOLDER, HEAD SPRING” and push it toward the “HEAD” side to
disengage the hooks on the right and left, and pull it out upwardly.
<Precaution at reassembly>
Align three “SPRING, HEAD-03” with the lugs at “SLIDE, HEAD SPRING-03”.
Align “SA, HEAD” with bosses on the right and left of “FRAME, MAIN-03” as well as the U-slots at “HOLDER,
HEAD SPRING”.
Insert the hook at “FRAME MAIN” until its end reaches the mark at “HOLDER, HEAD SPRING”.
Detach “SA, THERMAL HEAD-03” from the bosses on the right and left of “FRAME, MAIN-03”.
<Precaution at reassembly>
Align the slots at “SA, THERMAL HEAD-03” with the bosses on the right and left of “FRAME, MAIN-03”.
HOLDER, HEAD SPRING
Hooks
Insert "SPRING, HEAD-03"
into the grooves,
respectively.
Bosses
Insert the hook until its end reaches the
mark at "HOLDER, HEAD SPRING".
SA, THERMAL HEAD-03
Align the boss with
the U-slot.
To Next Page
Loading...
