CT-S310II Series Service Manual
- 14 -
Remove “SLIDE, HEAD SPRING-03” and “CABLE, HEAD FFC” from “SA, THERMAL HEAD-03”.
<Precaution at reassembly>
Check the mounting position of “SLIDE, HEAD SPRING-03”.
Connect “CABLE, HEAD FFC” with the conducting face facing upward.
Since the connector pins are sharply pointed, never touch the connector terminal.
Remove “SCREW, BH, M3.0 4” that fasten “SA, THERMAL HEAD-03” and “HOLDER, HEATSINK-03”.
<Precaution at reassembly>
Align the bosses at “HOLDER, HEATSINK-03” with the holes at “SA, THERMAL HEAD-03”.
SLIDE, HEAD SPRING-03
CABLE,
HEAD FFC
Conducting face
Check the positions.
Be careful not to touch the
connector terminal.
SCREW, BHT (ST), M3.0 6
Hole for boss
To Next Page
Loading...
