128
On Demand Reception
(Manual Reception)
•Signalscanbereceivedatanytime.
<Receiving the radio signals>
1. Pull the crown out to position 1 and turn to align the
mode hand with the CAL, TME or RX-S position.
2. Return the crown to the normal position.
3. Remove the watch from your wrist and place on a
stable surface near a window where the radio signal
can be easily received.
4. Point the 9:00 side of the watch in the direction of the radio wave transmitter, and
hold down the lower right button (A) for more than 2 seconds. Release when the
confirmation tone sounds and the second hand stops at RX. The second hand will then
move to H, M or L, and reception will begin.
* Do not move the watch during reception.
5. When the radio wave has been properly received, the second hand will automatically
move from H, M or L to the time that was received, all the hands will be corrected,
and the second hand will return to 1-second interval movement.
* Reception can take a maximum of 15 minutes.
[Mode hand position
when receiving]