■ 16. Using the Chronograph (CHR)
• The chronograph can display times up to 23 hours 59 minutes and 59.99 seconds.
• After it exceeds 24 hours, the measurement stops and the chronograph returns automatically
to the reset status.
• Radio waves cannot be received during chronograph
measurement.
<Using the chronograph>
1. Pull the crown out to position 1 and turn to align the
mode hand with CHR (chronograph mode).
2. Return the crown to the normal position.
3. A confirmation tone will sound each time you press
the upper right button (B) to start and stop the measurement.
4. Press
the lower right button (A) during measurement to
display a split time for 10 seconds. After the 10 seconds, the
watch returns to the measurement status. (Auto return function)
• The measurement mark is displayed during measurement and
during the split display.
• The SPL display flashes during the split time display.
5. Press
the lower right button (A) while the chronograph is
stopped to return to the chronograph reset status.
158
Measurement mark
Mode
switching
position
Button (A)
Button (B)
To Next Page
Loading...
