Citizen u680 - Page 64

169
4. Press the upper right button (B) to enter the automatic reception setting status.
• The set automatic reception status flashes.
• AUT, MAN and OFF flash and the watch enters the correction status.
5. Press the lower right button (A) to set the automatic reception operating condition to
MAN.
• The hour of the reception time flashes.
• Each time the lower right button (A) is pressed, the correction location changes in
the following sequence: AUT → MAN → OFF.
6. To change the reception time, turn the crown to change the time in 1-hour units.
• Turn the crown to the right to move the time forward and to the left to move the time
back.
• Only the 4 a.m. automatic reception can be changed. (2 a.m. and 3 a.m. are not
displayed.)
• Only the hour can be changed, and when using the 12-hour clock, “A” indicates a.m.
and “P” indicates p.m.
7. Press the crown back into its normal position.
* Nighttime is usually a good time for reception because radio wave noise is relatively
low.