192
Problem
Radio signals
cannot be
received.
The time is not
correct.
Check
• Is the mode hand pointing to
a mode other than TME, CAL
or RX-S?
• Is chronograph or timer
measurement in progress?
• Pull the crown out to position 1 and
set the mode to TME, CAL or RX-S.
• Stop the measurement, reset, and try
to receive the radio wave again.
• If the reference position is not
correctly set, adjust it as indicated in
“Adjusting the Reference Position”.
• Is the reference position set
correctly?
Check the reference position.
Remedy
To Next Page
Loading...
