67
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine : CFA
Refit the valve cover gasket in the groove of the valve cover and on the centring bosses indicated
by the arrows.
WARNING: Check the positioning of the gasket, which must be well seated around the bases of the
bosses.
.
"k" : 3 to 4 mm.
Apply a strip of seal paste "j" on the sealing faces of the cylinder head and of the timing cover.
Seal paste : AUTOJOINT OR.
WARNING: Refit the valve cover within 3 minutes and tighten the screws and nuts within 15 minutes
following application of the strip of seal paste "j".
B1D202WD
B1D200VD
To Next Page
Loading...
