CITROEN C2 2004 - Page 218

214
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: WJY
B1EP1EDC
Setting the timing (continued).
NOTE:
If necessary, you can slightly rotate the pinions (10) and (7) anti-clockwise in order to engage the belt.
The angular displacement value of the belt in relation to the pinions should not be more than half a tooth.
- Remove tool
[5].
- Act on the tensioner roller (8) by its square «a», using tool [6] to check that the camshaft and injection
pump pinions can turn freely.
- Position the belt tension instrument
[7] on the belt at «b».
- Using tool [6], act at «a» in the direction opposite to that of engine rotation, to obtain a tension value of
106 ± 2 SEEM units.
- Tighten screws (9), (5) and (6).
- Remove tools [7], [2], [3] and [4].
- Rotate the crankshaft 8 times in the normal direction of rotation.
- Peg the flywheel, using tool [2].
- Peg the camshaft hub, using tool [4].
- Peg the injection pump hub, using tool [3].
- Slacken screws (9), (5) and (6).
- Position the belt tension instrument [7] on the belt at «b».
- Using tool [6], act at «a» in the direction opposite to that of engine rotation, to obtain a tension value of
42 ± 2 SEEM units.
B1EP1EFC
XSARA