Citronix ci5300 - Autoprint Pitch; Height; Repeat Printing

ci5000 Series Printer Operation Guide
Version 1.0 3-45
修改粗体设置值，按粗体数值右侧的“编辑” 键。在列表中选择需要的数值（0-9 之间），然后按“保
存” 。
NOTE: The higher the bold setting the Longer the message. For example; a bold
setting of 3 will be longer than a bold setting of 1 or 0. 注意：
注意：注意：
注意：粗体设置值越大，信
息长度越长。例如，粗体设置值
3 ，信息长度会比设置 1 或 0 更长。
Height 字高
字高字高
字高
The Height setting defines the overall height of the message. To adjust the Height setting, press the [Edit]
button to the right of the Height valve. Adjust using the keyboard. Type the desired setting (between
50 and 255) then press [Save] . .字高设置决定信息的整体高度。调整字高设定， 按字高数值右
侧的“编辑” 键。利用键盘调整。输入设定的值（50-255）然后按“保存”
NOTE: Setting the height too low can cause the print to clip the gutter block. This
causes the printhead to also get dirty. Setting too high can also result in a dirty
printhead and multiple HV Faults. An average setting of 200 works best. 注意：
注意：注意：
注意：
字高设置太低可能引起回收管积墨造成打印缺失。也会弄脏打印头。字高设置太高
也会弄脏打印头和频繁高压故障。平均设定值
200 机器运行状态最佳
AutoPrint Pitch 自动喷印间距
自动喷印间距自动喷印间距
自动喷印间距
AutoPrint Pitch defines a fixed amount of time/space (in stroke’s/raster’s) from the beginning of one
message to the beginning of the next when in AutoPrint mode. To configure the pitch setting, press the
appropriate [Edit] button. Type the desired setting using the on-screen keyboard (between 0 and
999999999 then press [Save] .自动喷印间距决定了在自动喷印模式下，从一条信息的起始位
置到另外一条信息的起始位置之间固定的时间/间隔（以划速/列为数量单位）。调整间距设置，按“编辑”
键。在屏幕的软键盘上输入需要的设置值（0-999,999,999）然后按“保存” 。
Repeat Printing 重复喷印
重复喷印重复喷印
重复喷印
Some applications require the same message to be printed multiple times before being incremented. The
repeat printing property provides this functionality and can be configured by first configuring the number
of repeat messages and then specifying the pitch/distance between each repeat message as described