Citronix ci5500 - Service Module Error Stages

ci5000 Series Printer Operation Guide
Version 1.0 5-8
Error 故障
故障故障
故障
This error will appear in 4 stages to allow enough scheduling time to allow the printer to be shut down for
replacement so that this does not interfere with normal production runs. 在整个维护周期中机器将分 4 个
阶段提示过滤器更换时间，以保证不影响机器的正常运行
They are as follows: 它们的过程如下
1. The first error/warning will appear when the Service Module reaches 300 hours left before
expiring. This error/warning will reappear once a day. Usually at startup or in case of a 24/7
operation, the same time each day that it initially appeared. 第一阶段信息提示出现在过滤器剩余
时间为 300 个小时的时候。这个阶段的提示将每天显示一次。通常在开机的时候或 24/7（每周运
行 24 小时）运行的时候，每天在第一次信息提示的同一时间提示。
2. The second error/warning will appear at 150 hours left. This error/warning will reappear once and
hour until the next stage is reached. 第二阶段提示出现在剩余时间为 150 个小时的时候。这各阶
段的提示将每小时显示一次，直到条件满足下一阶段提示。
3. The third error/warning will appear when there is 50hours and less left. This error/warning will
reappear every 5 minutes until zero (0) hours are reached. 第三阶段提示出现在剩余时间小于等于
50 个小时。这个阶段的提示将每 5 分钟提示一次，直到剩余时间为 0。
4. This is the final error/warning and will appear when the module hours have reached zero (0). At
this time the printer will perform a controlled shutdown and will not run until the Service Module is
replaced and a new tag scanned resetting the hours. 当过滤器剩余时间为 0 的时候，这是最后的
警告并且将一直显示。在这个时候，喷码机将被强制执行关机并被锁住，直到更换新的“快易护”
模块并读取一次信息，复位使用时间。