CLA-VAL D35
Communicating Valve Controller
CLA-VAL Europe www.cla-val.ch cla-val@cla-val.ch 19 - D35001UE - 08/22
© Copyright CLA-VAL Europe - Specifications subject to change without notice - no contractual illustrations. Reduce your waste - Sort your rubbish
9.8.4 « ACTION » CONFIGURATION
Name: The action name.
Output: The solenoid valve output which is controlled by this action.
Activation state: The state of the solenoid valve when the action is active.
Activation delay [s]: The activation delay allows you to add a delay before the action is activated when these
different conditions are met. Only available in advanced mode .
Deactivation delay [s]: The deactivation delay allows you to add a delay before the action is deactivated even if its
conditions are no longer met. Only available in advanced mode .
Max. duration of an activation [s]: The maximum time during which the action can be active, if it exceeds this time
the solenoid valve will deactivate and can reactivate only when the action deactivates and reactivates again. A
value of 0 disables this option. Only available in advanced mode .
Priority (1 : High): When several actions control the same output, the priority defines which action will have control
over the output. The action with the value closest to 1 has priority, in case of a tie the order of the actions prevails.
9.8.5 CONDITIONS
Conditions determine when an action is active or inactive. You can set up to a maximum of three conditions per action.
You can choose to join the conditions with "or logic" or "and logic".
The conditions available are:
Threshold
Calendar
Volume + Calendar
Chapter 9.8.4
Chapter 9.8.4
Chapter 9.8.5
To Next Page
Loading...
