12
Adjusting the cutting height, ground pressure or pre-set cutting height
While driving it is possible to adjust the cutting height / ground pressure from a pre-
set position using 2 methods.
1. Use buttons (1a) (1b) to adjust the height and then press and hold button (1d) or
(1c) for 3 seconds and a buzzer will sound to indicate the new value has been saved.
2. Using button (9) it is possible to raise or lower the Cutterbar while working and
the new position will be saved into the active mode, either, cutting height, ground
pressure or pre-set cutting height.
Setting and adjusting
the cutting height
To Next Page
Loading...
