Clarion CZ201 - Unit Removal and Trim Ring; Removing the Source Unit

English
24
Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
2. Push the trim ring to left and pull out the
left part.
Disassemble the unit
5YKVEJQHHVJGRQYGT
2. Remove the panel.
3. Remove the trim ring.
+PUGTVVJGTGOQXCNMG[UUVTCKIJVDCEMWPVKN
they lock, then pull the unit out.
 &KUEQPPGEVCNNVJGYKTGU
Method B
6) Removing the Source Unit
Mounting Frame
&CUJDQCTF
M5x6
1. Insert this unit directly to the opening of
VJGFCUJDQCTF
2NCEG/ªE[NKPFTKECNUETGYVJTQWIJVJG
holes of the mounting frame located inside
the opening to holes of the unit and fasten
VJGUETGYUVQNGHVTKIJV
Trim Ring installation
Attach the trim ring around the front panel.