EasyManua.ls Logo

Clarion FZ502E - 7. Specifications 8. Installation; Wire Connection Guide; 7 Specifications; 8 Installation; Wire Connection Guide; Before Starting

Clarion FZ502E
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
11
FZ502E
FM Tuner
Frequency range: 87.5-108.0MHz
Usable sensitivity: 8dBμ
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
MW Tuner
Frequency range: 531-1602kHz
Usable sensitivity (S/N=20dB): 30dBμ
LW Tuner
Frequency range: 153-279kHz
Usable sensitivity (S/N=20dB): 34dBμ
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
Joliet le system
USB
Specication: USB 1.0/2.0
Playable audio format:
MP3(.mp3): MPEG 1/2/Audio Layer-3
WMA(.wma): Ver 7/8/9.1/9.2
Bluetooth
Specication: Bluetooth Ver. 2.0+EDR
Prole: HFP (Hands-free Prole)
PBAP(Phone Book Access Prole)
A2DP (Advanced Audio Distribution Prole)
AVRCP (AV Remote Control Prole)
Send/Receive Sensitivity: Class 2
Audio Amplier
Maximum power output:
180W (45W x 4)
Speaker impedance: 4Ω (4 to 8Ω allowable)
7. SPECIFICATIONS
Input
Audio input sensitivity:
High: 320mV (at 1V output)
Mid: 650mV (at 1V output)
Low: 1.3V (at 1V output)
(input impedance 10 kΩ or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 190mm Depth
Weight of the Main Unit: 0.88kg
Dimensions of the Remote Control unit:
52mm Width × 7.5mm Height × 85.5mm Depth
Weight of the Remote Control Unit:
24g (including battery)
Note:
Specifications and design are subject
to change without notice for further
improvement.
8. INSTALLATION / WIRE
CONNECTION GUIDE
1) Before Starting
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “terminal” before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
CONTENTS
1) Before Starting ......................................................................11
2) Package Contents ................................................................. 11
3) General Cautions ..................................................................11
4) Cautions on Installation ......................................................... 12
5) Installing the Source Unit ......................................................12
6) Removing the Source Unit ....................................................13
7) Wiring and Connections ........................................................ 13
8) Connecting the accessories .................................................. 14
Source unit ..........................................1
Trim ring ..............................................1
Mounting bracket ................................. 1
Screws M5x6 mm ................................ 4
L-key .................................................... 2
Rubber cap .......................................... 1
Special screw(M4x42) ......................... 1
Wire connector ....................................1
Owner’s manual...................................1
Warranty card ...................................... 1
Remote control (with battery) ..............1
Car battery
Figure 1
130.com.ua
Autogood products «130»

Related product manuals