Clarion FZ502E - Removing the Source Unit; Wiring and Connections

English
13
FZ502E
Method B
6) Removing the Source Unit
Mounting Frame
Dashboard
M5x6
1. Insert this unit directly to the opening of
the dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
2. Push the trim ring to left and pull out the
left part.
Disassemble the unit
1. Switch off the power.
2. Remove the trim ring.
3. Insert the removal keys straight back until
they lock,then pull the unit out.
4. Disconnect all the wires.
Trim ring installation
Attach the trim ring around the front panel.
7) Wiring and Connections
Refer to next page
Antenna
(Black)
Front audio output terminal
Black
Gray
White
White
Left
Right
Red
Red
External microphone
(RCB-199:Sold by
separately)
Rear audio output (Left) /Subwoofer output1
Rear audio output (Right) /Subwoofer output2
SWC
4 Channel Amplier
Black
Black
Steering wheel
control terminal
A
B
2
4
6
8
1
3
5
7
1
3
5
7
2
4
6
8
C
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
MIC
130.com.ua
Autogood products «130»