70
Button Description
Units
You can set the distance units to be used by the program. Clarion
Mobile Map may not support all the listed units in some voice
guidance languages. If you select a measurement unit not supported
by the chosen voice guidance language, a warning message will
appear.
Set Date & Time Format You can set the date and time format. Various international formats
are available.
Time and Time Zone Settings You can access time and time zone settings. Clarion Mobile Map
helps you with correcting the device time to the ever accurate GPS
time. Clarion Mobile Map can also help you set the time zone based
on your current GPS position.
Time and Time Zone Settings:
Button Description
Auto Time Correction to GPS Use this feature to synchronize the clock of your device to the highly
accurate time provided by the GPS receiver.
Use Auto Time Zone
Use this feature to synchronize the time zone of the clock of your
device to the time zone based on your current GPS position. This is
useful if you travel abroad.
Set Time Zone Set time zone manually if you do not want to synchronize the time
zone automatically. This allows you to use Auto Time Correction and
apply a time zone offset to obtain the desired time.
Compare GPS and device
times
The current time of the GPS receiver and the device clock are
displayed. Please note that the GPS clock is only available with GPS
reception. This allows you to check whether any correction is needed.
4.5.5 Navigation settings
You can control how Clarion Mobile Map behaves during navigation. Tap the following buttons: ,
, .
Button Description
Keep Position on Road
This feature allows car drivers to always correct GPS position errors
by matching the vehicle position to the road network.
By turning off this feature you also turn off the GPS position error
filtering. The position shown on the map will be subject to all position
errors and position fluctuations.
Off-route Recalculation
This switch tells Clarion Mobile Map whether to automatically
recalculate the route when you deviate from it. If this feature is turned
off, you need to initiate route recalculation manually otherwise
navigation will be stopped until you return to the originally
recommended route.
Setting another point than the current GPS position as the start point
To Next Page
Loading...
Need help?
General
