Clarion NX700 - 5. SOURCE OPERATIONS; Radio Operations

NX700/NX700E
- 21 -
1-4. Installation of LCD (3)
No. PARTS CODE
Q'T
Y
1. Peel off the separator from Earth plate(A) A 331-3038-00 1
and stick it on LCD holder(B). (Fig.1) B 331-4803-00 1
2. Attach processed LCD to * Fit at 8 tab.
processed Escutcheon
after the blow of air. (Fig.2)
3. Insert Lead(2P) on the LCD side
in the socket of LCD PWB. (Fig.3)
4. Attach LCD PWB on LCD holder * Twist tabs according to
while holding Flex-PWB on the LCD side, the silk print.
and twist the 2 tabs.
(Fig.4)
WORKING DIAGRAM WORKING PROCESS WORKING POINT
B
A
LCD-PWB
processed
Escutcheon
(Fig.1)
(Fig.2)
(Fig.3) (Fig.4)
(A)
(
B
)
LCD PWB
2P lead
twist the tab
tab
tab tab tab
tab
tab
tab
tab
twist the tab
1-6. Installation of Rear cover (1)
No. PARTS CODE
Q'T
Y
1. Turn the left of rear cover to up, A 331-4804-10 1
apply grease on the shaft.
2. Insert the spring and the roller B 750-6746-10 1
in shaft(left side) of rear cover. C 335-7074-00 1
3. Turn the right of rear cover to up,
apply grease on the shaft.
4. Insert the spring and the roller D 750-6746-10 1
in shaft(right side) of rear cover. E 335-7074-00 1
WORKING DIAGRAM WORKING PROCESS WORKING POINT
apply grease
A
B
C
D
E
apply grease
1-5. Installation of LCD (4)
No. PARTS CODE
Q'T
Y
1. Unlock Flex-socket (J102,J104,J105)
of LCD PWB.
2. Insert FPC of Panel PWB-B * Insert it while holding Flex-PWB.
into Flex-socket(J105) of LCD PWB, * Do not never touch it
and lock it. after locking.
3. Insert Flex-PWB of LCD * Insert it while holding Flex-PWB.
into Flex-socket(J104) of LCD PWB, * Do not never touch it
and lock it. after locking.
4. Insert Flex-PWB of touch panel * Insert it while holding Flex-PWB.
into Flex-socket(J102) of LCD PWB, * Do not never touch it
and lock it. after locking.
5. Arrange FPC of Panel PWB-B
under LCD PWB.
WORKING DIAGRAM WORKING PROCESS WORKING POINT
Flex-socket
(J105)
Flex-PWB of
touch panel
Flex-PWB of
LCD
FPC of
Panel PWB-B
Flex-socket
(J104)
Flex-socket
(J102)