Cautions on Wiring
1.
Be
sure to turn the power off before wiring.
2.
Be particularly careful where you route the wires.
Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
3.
If the fuse should blow, check to see if the wiring is correct.
If a fuse
is
blown, replace it with a new one of the same amperage rating
as
the original (15A
FUSE).
4.
To
replace the fuse, remove the old fuse
on
the back of the unit and insert the new one. (Figure
8)
NOTE:
There are various types
of
fuse holder Do not let the battery side touch other metal parts.
A cAUTION
After the connection, fix the cord
by
a clamp
or insulation tape for protection.
-Fuse (15A
FUSE)
Fuse holder
Figure 8
NZ503
37
To Next Page
Loading...
