Clarion NZ503 - Audio Setup Menu; Navigation Setup Menu; Others Setup Menu

52 NZ503
English
Owner’s Manual
Audio Setup Menu
4HISMENUINCLUDES"ALANCE&ADER3ELECT%13UB
7OOFER#TRL3UB7OOFER0HASE(IGH0ASS&ILTERLOW
0ASS&ILTER!MP#ANCELAND-AGNA"ASS%8
Balance: Choose the desired volume for left and right
speaker.
Fader: Choose the desired volume for front and rear
speaker.
Select EQ:#HOOSETHEDESIREDMODE"ASS"OOST
)MPACT%XCITE#USTOMAND/&&
Sub Woofer Ctrl: Choose the desired sub woofer gain
from 0 to 14.
Sub Woofer Phase: Choose the sub woofer phase
normal or reverse.
High Pass Filter: #HOOSETHEHIGHPASSlLTER
THROUGH(Z(Z(Z
Low Pass Filter:#HOOSETHELOWPASSlLTER
THROUGH(Z(Z(Z
Amp Cancel:#HOOSETHEAMPLIlERAUDIOOUTPUTON
or off.
Magna Bass EX: Choose the loudness on or off.
Navigation Setup Menu
4HISMENUINCLUDES'034IME.AVI)NTERRUPTAND
6OICE'UIDANCE
GPS Time:3ETTHESYSTEMTIMETOBESYNCHRONIZED
WITH'03LOCALTIMEORNOT
Navi Interrupt:4HEREARETHREECHOOSE/N0OPUP
/FFh/Nv4HENAVIGATIONSCREENWILLCOVERTO!6
SCREENWHENREACHINGSOMEKEYPOINTh0OPUPv7HEN
small turn info window will pop up in the top of the
!6SCREENTOINDICATETHEKEYPOINTh/FFv4URNOFFTHIS
function.
Voice Guidance: Enable or disable the navigation
voice guidance.
Voice Guidance Mix:4HEREARETWOCHOOSE/N/FF
h/Nv4HENAVIGATIONVOICEGUIDANCEWILLPLAYATTHE
SAMETIMEANDTHEVOICEOFTHECURRENTSOURCEh/FFv
/NLYTHENAVIGATIONVOICEGUIDANCE6OICE'UIDANCE
/N
Others Setup Menu
Set password:3ETTHEPASSWORDFOR$6$PARENTAL
control.
Parental control:3ETTHERATINGOFTHEAGE)TCONTAINS
+ID3AFE'0'0'0'22.#!DULT
Audio Language:3ETTHE,ANGUAGEFOR$6$!UDIO
Subtitle Language:3ETTHE,ANGUAGEFOR$6$SUBTITLE
System Language: 3ETTHE,ANGUAGEFORSYSTEM
screen.
Blinking LED: 3ELECTTHEBLINKING,%$/N/FF
Screen Calibrate:4HEFUNCTIONOFITISTOSELECTTHE43
#ALIBRATE9%3OR./
Factory Default: The function is to select to load
factory default or not.