Clarion NZ503 - Page 41

Connecting
the
parking
brake
cord
Connect the cord to parking brake lamp
ground
in
the meter
panel.
Note:
•
Connecting the parking brake
cord
to lamp ground allows you to watch iPod/iPhone video/OVD video/
AV
input when
the parking brake
is
engaged.
•
When the parking brake
cord
is
not
connected, the monitor will
not
show any video sources.
•
If "AUDIO ONLY'
appears on the screen just after turning on the
ACC
power
of
the
car,
release the parking brake
while confirming safety,
and
then engage the parking brake again.
Electro-tap
cord to battery
Parking
brake
signal
cord
Parking
brake cord
(Grass-green)
Connecting the accessories
•
Connecting
to
the
external amplifier
How
to
attach
the
electro-tap
1.
Place the Parking
brake cord at the stopper, and
fold
it back
in
the direction of the arrow
2.
Pass
the
Parking
brake
signal
cord through, and
fold
it back
in
the direction of the arrow.
Parking
brake
signal
cord
Parking
brake
~
/
signal~
~~
Parking
brake cord
(Grass-green)
The
external amplifiers
can be connected to the 6 channel
RCA output connections. Ensure that the connectors
are not grounded or shorted to prevent damage to the unit.
•
Connecting
to
iPod/iPhone device
The
iPod/iPhone device can be connected to dedicated
iPod/iPhone
connection
on
the main unit. For
detailed
information, refer to the instruction sheet or
manual
for the iPod/iPhone cable.
Note:
•
This
unit may
not
support
all
functions
of
all
iPod/iPhone devices.
•
The
iPodl
/Phone connection will charge your iPodliPhone unless the iPod/iPhone battery
is
completely depleted.
If
the specified
cord
of
the cellular phone
is
connected to the phone interrupt cord
of
the main unit, the audio mute
is
activated when cellular phone
in
use.
• Connecting
to
SiriusXM Radio Receiver
When SiriusXM Radio Receiver
is
to be connected, use the dedicated connector. For
detailed
information,refer
to the instruction
manual of the SiriusXM Radio Receiver.
40 NZ503