DVD Changer Operations
Only basic operations
of
DVD changer can be
performed from the unit. Use the remote control
unit to perform the following functions.
• SCAN, REPEAT, RANDOM function
• V-CD PBC function ON/OFF
• DVD
SETUP
function, AUDIO, SUBTITLE,
ANGLE setting function
For details on operations other than those
described below, see DVD player Operation.
For details on DVD changer precautions, refer
to the supplied owner's manual.
Note:
• When the
DVD
changer (VGZ625) is connected
via optical cable, no sound will be output
if
AUDIO
OUT
is switched
to
ANALOG on the changer's
"GENERAL SETUP" menu.
Selecting a
disc
When
the
panel
is
closed:
Each of the [DIRECT] button corresponds to a
disc loaded into the DVD changer.
Press the [DIRECT] button
(1
to 6) and select
the desired disc.
When
the
panel
is
open:
Touch the [LIST]
key,
otherwise press the [DISC
SEL]
button on the remote control unit.
Touch the [DIRECT] key
(1
to 6) in the display
or
press the numeric button
for
the disc number
(1
to 6) on the remote control unit to select the
desired disc.
Switching
to a
next
disc
(Disc Up function)
The disc up function plays from the first track
(track No.1)
of
the next disc.
Press the
[BAND]
button.
Each time you press the
[BAND]
button, the
disc changes to the next disc.
*When the remote control unit supplied with the
DVD
changer (VCZ625) is used to operate this
component, some operation buttons are not
supported.
50 VRX755VD
TV Operations
TV
functions
When an optional
TV
tuner is connected through
the
CeNET
cable, this unit controls all
TV
tuner
functions.
To
watch
TV
requires a
TV
tuner.
.A
WARNING
For
your
safety, the driver
should
not
watch the
TV
or
operate
the
controls
while driving. Please note
that
watching
and operating the TV while driving are
prohibited
by
law in some countries.
Watching TV
Note:
• For your safety, the VRX755VD has a safety
function which turns
off
the picture when the car
is moving,
so
only the audio can be heard. The
picture can only be watched when the
car
is
stopped
and
the parking break is applied.
1.
Press the [SOURCE] button and select the
TV
mode.
2.
Press the
[BAND]
button
to
select the
desired
TV
band (TV1
or
TV2). Each time
the button is pressed, the input selection
toggles between TV1 and TV2.
3.
Press the [...
>]
or
[<
....
] button to tune in the
desired
TV
station.
*When the panel
is
open, the same operation
is also available by using the [
.......
] or
[~]
key.
Watching a video
The
TV
tuner has a
VTR
input terminal to which
1 external
device can be connected. Connect a
12V
video cassette player (VCP)
or
video
cassette recorder (VCR) to the TV tuner input
terminal.
1. Touch the screen to display the menu, then
touch the [SUB]
key.
2. Touch the
[EXTRA
SELECT] key in the
menu screen when the "VTR" is displayed.
3.
To
return to the
TV
broadcast, touch the
screen again and touch the [EXTRA
SELECT] key
in
the menu screen.
To Next Page
Loading...
Need help?
General
