• Fixed
Mount
(TOYOTA, NISSAN and
other
ISO/DIN
equipped
vehicles)
This unit is designed for fixed installation
in
the
dashboard.
If the vehicle
is
equipped with a factory-installed
radio, install the main unit with the parts and
screws marked
(*). (Figure
8)
If the vehicle is not equipped with a factory-
installed radio, obtain an installation kit to install
the main unit
in
the following procedure.
1.
Remove the screws from both side of the
main unit. Then, at either side, lift the leaf
spring until the engaging claws are released
from the holes, and slide the spring to the
direction of arrow to remove
it.
Repeat the
same for the other side to remove the
springs from the both sides. (Figure
7)
2.
Secure the mounting brackets to the chassis
as shown
in
Figure
8.
Holes are pre-tapped
for
TOYOTA
and NISSAN vehicles;
modification, such as drilling new holes, of
the mounting brackets may be required for
other models.
3.
Wire as shown
in
Section
8.
4.
Secure the unit
in
the dashboard, and then
reassemble the dashboard and the centre
panel.
Figure 8
2-Screw
Centre Panel (Note 1)
*:
The screws with
this
mark are
enclosed
in
this
set.
*:
The
parts
and screws
with
this
mark
are used
to
install radio
or
included
in
the installation kit.
Note2
~
~
Engaging claw
Note 1: In
some
cases, the centre
panel
may
require some modification (trimming,
filling, etc.).
68 VRX755VD
Note
2:
If
a
hook
on the installation bracket
interferes with the unit,
bend
and
flatten
it
with a
nipper
or
a similar tool.
To Next Page
Loading...
