Clarion Ungo Pro Security RK1 Installation Guide

39
power-up
The power-up feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if
power is disconnected during a full trigger sequence, the system will still be in the full trigger
sequence when power is reconnected to the unit. If power is disconnected while the unit is disarmed,
it will still be disarmed when power is restored.
timer mode
By pressing the remote and buttons the parking lights will flash 4 times and then start the
vehicle and run for the set duration. The remote start can be shut off by the remote by pressing the
remote start button and remain in timer mode, but if any other shut down zones or the ignition
becomes active the timer mode will cancel.
1. Press Timer mode buttons.
2. The vehicle will confirm with 4 parking light flashes.
3. A 1-second delay will start.
4. The system will start the car and will run for the specified duration, unless shut down by the remote
start button . If shut down with the remote start button the system will remain in timer mode.
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.
To exit timer mode, turn the ignition switch on any time the engine is running. The parking lights will
flash 4 times, indicating timer mode has been exited.
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.

Clarion Ungo Pro Security RK1 Specifications

General

Brand	Clarion
Model	Ungo Pro Security RK1
Category	Car Alarm
Language	English