28
remote coding
The system comes with remotes that have been taught to the receiver. The receiver can store up to 4
different remote codes in memory. Use the following remote coding to add remotes to the system or
to change button assignments if desired.
The remote coding may be locked if previously programmed using the Pro Security Programmer. If
the horn generates one long honk when attempting to program the unit, the remote coding is locked
and must be unlocked using the Pro Security Programmer before proceeding.
The Override switch, plugged into the blue port, is used for coding. There is a basic sequence of steps
to remember whenever programming this unit: Key, Choose, Transmit and Release.
1. Key. Turn the ignition to the ON position.
2. Choose. Within 10 seconds, press and release the Program switch the number of
times corresponding to the desired channel listed below. Once you have selected
the channel, press the switch once more and hold it. The LED will flash and the
horn will honk (if connected) to confirm the selected channel. Do not release the
Program switch.
To Next Page
Loading...
Need help?
General
