30
remote coding will be exited if:
● Ignition is turned off.
● Program switch is pressed too many times.
● More than 15 seconds elapses between programming steps.
One long horn honk indicates that remote coding has been exited.
remote configurations
The remotes can be programmed with the separate or single button arm/disarm configurations by
using the Auto-learn functions in the remote coding.
button configuration
controls the Lock/Panic ON/Panic OFF function.
controls the Unlock function.
controls Silent Lock/Unlock and an Auxiliary Output.
controls Remote Start.
/ controls Timer mode.
+ controls Turbo/Short Run.
+ controls Channel 4 output.
module programming
The system features programmed dictates how the unit operates. Due to the number of fea-
tures, the features have been divided into two menus. It is possible to access and change any
of the feature settings using the Override switch. However, this process can be greatly simplified by
using the Pro Security Programmer. Any of the settings can be changed and then assigned to one of
To Next Page
Loading...
Need help?
General
