Clarion VRX8370R - Page 8

The control panel can be detached to prevent
theft. When detaching the contro! panel, store it
in
the
DCP
(Detachable
Control
Panel)
case
to
prevent scratches.
We
recommend
taking
the
DCP
with
you
when
leaving
the
car.
Removing the DCP
1) Turn the power off.
2)
Deeply
push
in
the
DCP
release
lever
[4]
to
release the DCP/Operation Panel [11].
DCP release lever
Attaching the DCP
1) Hold the DCP/Operation Panel [11] with its
rear side facing the source unit and, as
shown in the figure below, put the lower edge
of the panel onto the corresponding edge of
the source unit.
8 VRX8370R
rs
DY
©
dm
(BY
=)
F-[evat-1e)(-m
Orel
alige)
Panel)
2) Lock the DCP/Operation Panel [11] at the
upper centre until a click is heard.
POWER button
3)
Press
the
POWER
button
[7]
to
turn
on
the
power.
e The DCP can easily be damaged by
shocks. After removing it, be careful not to
drop it or subject it to strong shocks.
e if the Operation Panel is kept open, the
DCP may drop due to vibration of the car.
This results in damage to the DCP. So close
the Operation Pane! or remove the DCP to
store into the case.
(See figure below.)
e The connector connecting the source unit
and the DCP is an extremely important
part. Be careful not to damage it by press-
ing on it with fingernails, screwdrivers, etc.
Note:
e /f the DCP is dirty, wipe off the dirt with a soft, dry
cloth only.