Clark NPR17 - Page 78

Recommended PM Intervals
The maintenance time intervals referred to in this manual relate to truck
operating hours as recorded by the diagnostic system and based on
experience which CLARK has found to be convenient and suitable
under typical (normal or average) operating conditions, as follows:
A = 8-10 hours or daily
B = 50-250 hours or every month
C = 450-500 hours or every 3 months
D = 900-1000 hours or every 6 months
E = 2000 hours or every year
Component Locations
Use the illustration below to help you locate components included in the
PM procedures.
1. Overhead Guard
2. Multi Function Handle
3. Steering Assembly
4. Sump Tank
5. Steer/Aux Pump Motor
6. Brake Fluid Reservoir
7. Drive Motor
8. Drive Unit
10
11
12
15
13
14
9. Caster
10. Battery Disconnect
11. Transistor Drive Control
Panel
12. Pantograph
13. Battery
14. Battery Retainer
15. Steer Control
6-4 Component Locations