Clark TWLi20 - Operator Settings

55
Section 4. Operating the Display
Operator Settings
Operator Settings
Operator Settings
Name Description Menu Operation
Brightness
Allows for adjustment of the
display brightness level, use
the PLUS (3) and MINUS (4)
buttons.
Adjusted Using Menu Buttons
Performance
Modes
Allows for the acceleration
mode and speed mode to be
adjusted separately by the
operator or to lock the mode
selection to either H/S or L/E.
Adjust Performance Mode
DISPLAY → PARAMETER SET → SPE
MODE OPTION → OFF (0) or ON (1)
Units
The unit of measurement for
the speed icon can be shown in
either SI or US customary.
Adjust Unit of Measurement
DISPLAY → PARAMETER SET →
SPEED UNIT → MPH or KM/H
Speed Mode
The speed mode can be set
to always be the same at truck
startup.
Adjust Speed Mode
DISPLAY → PARAMETER SET →
START SPEED → MEDIUM (0), LOW
(1), or HIGH (2)
Acceleration
Mode
The acceleration mode can be
set to always be the same at
truck startup.
Adjust Acceleration Mode
DISPLAY → PARAMETER SET →
START ACC → FAST (0), SLOW (1), or
MEDIUM (2)
Language
The dash display can be set to
show either English or Chinese.
Adjust Language
DISPLAY → PARAMETER SET →
LANGUAGE → ENGLISH (0) or
CHINESE (1)
Password
The password is adjustable and
must be 5-digits in length.
Adjust Password
DISPLAY → SET PASSWORD →
ENTER NEW PASSWORD
Key Beep
The key beep can be turned
ON or OFF.
Enable / Disable Key Beep
DISPLAY → PARAMETER SET → KEY
BEEP → ON or OFF