Clarke 510B - User Manual

Questions and Answers

R
Robert ShortAug 4, 2025
Why is the Clarke 510B Scrubber vacuum inadequate?
- N
  Nicole AdamsAug 4, 2025
  There are several reasons why the vacuum on your Clarke Scrubber might be inadequate: * The recovery tank might be full, in which case you should drain it. * The drain hose or squeegee hose may not be properly connected; ensure they are securely connected. * The float filter or inlet could be blocked, requiring you to clean the float filter. * The squeegee may be dirty, or the squeegee blade could be worn, cracked, or brittle. Clean and inspect the squeegee. * The recovery tank lid may not be properly sealed, or the recovery tank seal/gasket may be damaged. Refit the lid properly or replace the recovery tank seal/gasket.
K
Kimberly KlineAug 8, 2025
How to troubleshoot a Clarke 510B Scrubber when the indication light is off?
- K
  Karen HughesAug 8, 2025
  If your Clarke Scrubber isn't working and the indication light is off, the issue might be with the battery connection or the battery itself. First, check if the battery connector is connected and connect it if it is not. If the connector is fine, the battery power may be exhausted, so charge the battery.
V
victorwongAug 12, 2025
What to do if the Clarke 510B squeegee is leaving marks?
- C
  Crystal SmithAug 12, 2025
  If the squeegee on your Clarke Scrubber is leaving marks, it could be due to a few reasons. There might be debris fragments under the squeegee blade, which you should remove. Alternatively, the squeegee blade might be worn, cracked, or brittle, in which case you should replace it. Finally, the balance of the squeegee might not be adjusted properly; try adjusting the balance.
A
Angela SmithAug 16, 2025
Why are warning lights (39 and 40) flashing on my Clarke Scrubber?
- M
  Melvin GordonAug 17, 2025
  If warning lights 39 and 40 are flashing on your Clarke Scrubber, this typically indicates that the brush motor is overloaded or that something is preventing the brush from spinning. Try changing the brush. If that doesn't solve the problem, clear any obstructions that may be preventing the brush from spinning.
E
Erik CrawfordAug 21, 2025
What to do if the Clarke 510B brush is not working?
- J
  jennifer28Aug 21, 2025
  If the brush on your Clarke Scrubber isn't working, there are a couple of things you can check. The brush fuse may have tripped off, in which case you should reset it. Also, the belt might be slipping, so you should check it.
G
gbergAug 26, 2025
How to fix a Clarke 510B with a vacuum motor that is not working?
- M
  matthew04Aug 26, 2025
  If the vacuum motor on your Clarke Scrubber isn't working, the vacuum fuse may have tripped off. Try resetting it.
E
Emily AndersenAug 30, 2025
Why is the water supply to the brush inadequate on my Clarke 510B?
- P
  Paul DavisAug 30, 2025
  If the water supply to the brush on your Clarke Scrubber is inadequate, the filter might be dirty. Try cleaning it.