Clarke CA30 17E - User Manual

Other manuals for Clarke CA30 17E

Questions and Answers

T
Terry ReidAug 1, 2025
What to do if Clarke CA30 17E has inadequate vacuum?
- L
  Leslie PhillipsAug 1, 2025
  If your Clarke Scrubber has inadequate vacuum, several issues could be the cause. First, check if the recovery tank is full and drain it if necessary. Ensure the drain hose and squeegee hose are correctly connected. Inspect the float filter for blockages and clean it, checking the float itself. The squeegee might be dirty or the blade worn or damaged, so clean and inspect it. Lastly, verify that the recovery tank lid is properly sealed and that the seal/gasket isn't damaged; refit or replace as needed.
R
rpetersonAug 8, 2025
What to do if Clarke CA30 17E Scrubber vacuum motor is not working?
- G
  George PowellAug 9, 2025
  If the vacuum motor on your Clarke Scrubber isn't working, it could be due to a few reasons. The wiring might be incorrectly connected or damaged, so check the wiring. Alternatively, the vacuum motor itself could be faulty, or the carbon brush might be worn out. In any of these cases, it's best to contact your Clarke Distributor.
S
Sean JonesAug 16, 2025
How to fix squeegee leaving marks for Clarke CA30 17E?
- H
  huntmichelleAug 16, 2025
  If the squeegee on your Clarke Scrubber is leaving marks, there might be debris fragments under the squeegee blade; remove them. The squeegee blade could also be worn, cracked, or brittle, in which case you should replace it. Another possible cause is that the balance of the squeegee is not adjusted; adjust the balance to resolve this issue.
J
Joseph JohnsonAug 25, 2025
What to do if Clarke CA30 17E Scrubber has little or no solution flow?
- T
  tiffanyvegaAug 25, 2025
  If your Clarke Scrubber has little to no solution flow, the filter might be dirty; clean it. The ball valve position may also need adjustment; when the ball valve is in a horizontal position, the amount of solution flow is maximum. Other potential causes include a bad ball valve or solution valve, in which case you should contact your Clarke Distributor.