14
MITRE GAUGE - DISC SANDER
A mitre gauge can be used on the
work table, as shown. The mitre
gauge head can be set anywhere up
to 60
o
(right or left) by loosening the
lock-knob, setting the mitre gauge
head to the desired angle, and
tightening the lock-knob.
SANDING SMALL SURFACES USING THE MITRE GAUGE
Use of the mitre gauge is recommended for sanding small end surfaces on the
sanding disc.
NOTE: Always move the workpiece across the left side (dust chute end
of machine) of the sanding disc and be sure to hold the
workpiece down tightly onto the table surface.
MAINTENANCE
1. Clean the sander, belt and disc after each use.
2. Keep the sander dry, clean and free from oil and grease.
3. Store the sander in a safe and dry place, out of reach of children.
4. During normal use, sanding belts and discs can become loaded with
sanding debris. Use a stick belt cleaner (available at most hardware stores)
to remove build-up.
WARNING: ALWAYS DISCONNECT THE SANDER FROM POWER SOURCE
BEFORE MAKING ANY ADJUSTMENTS, INSTALLING BELTS/DISCS.
CAUTION: SERVICING MUST BE PERFORMED ONLY BY QUALIFIED REPAIR
PERSONNEL. SERVICE OR MAINTENANCE PERFORMED BY UNQUALIFIED
PERSONNEL COULD RESULT IN A RISK OF INJURY. WHEN SERVICING A
TOOL, USE ONLY IDENTICAL REPLACEMENT PARTS. FOLLOW
INSTRUCTIONS IN THE MAINTENANCE SECTION OF THIS SERVICE MANUAL.
USE OF UNAUTHORISED PARTS OR FAILURE TO FOLLOW MAINTENANCE
INSTRUCTIONS MAY CREATE A RISK OF ELECTRIC SHOCK OR INJURY.
To Next Page
Loading...
Need help?
General
