4
15. NEVER operate machine while under the influence of drugs, alcohol or any
medication.
16. NEVER leave machine running unattended. Turn power off. Do not leave
the machine until it comes to a complete stop.
17. NEVER force the machine, it will do a better and safer job at the rate for
which it was designed.
18. NEVER use power tools in damp or wet locations or expose them to rain. Do
not use in an explosive atmosphere (around paint, flammable liquids etc.)
Avoid dangerous environments.
19. If the tool begins to make an abnormal noise, or produce excessive
vibrations, smoke or burning odour, turn the tool off immediately and do
not operate until repaired.
EXTRA PRECAUTIONS FOR BELT/DISC SANDERS
1. ALWAYS wear ear protectors/defenders when using this machine.
2. ALWAYS wear a dust mask when using this machine. Be aware that harmful
or toxic dust could be produced when sanding some woods.
3. ALWAYS use the table to support the workpiece.
4. ALWAYS check to ensure the table and attachments are secure before
starting.
5. ALWAYS maintain a clearance of 2-3mm between table and sanding disc.
6. ALWAYS hold the workpiece firmly so that it cannot be torn from your
hands.
7. ALWAYS feed the workpiece against the direction of rotation of the disc. i.e
the LEFT side of the disc.
8. ALWAYS keep the mains cable well away from the machine and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
9. ALWAYS use a dust extraction device, properly connected to the dust
extraction port.
10. ALWAYS ensure that nails or foreign objects have been removed from a
workpiece beforehand. Nails etc. will destroy the belt or disc.
11. NEVER allow the ventilation slots in the motor to become blocked.
12. NEVER sand pieces which cannot be held firmly by hand.
To Next Page
Loading...
Need help?
General
